Air Conditioner Freon Leak Repairs

During the summer months one of the most common problems with air conditioning systems is getting low on freon. This is a qoute that normally ends with the air conditioning contractor putting a few pounds of freon in and calling it quits. This is not the literal, way to solve the solution, and never a mend that will last forever. By going through the next steps I have provided in this article you can warrant your air conditioner will work next year.

The way an air conditioning law works is by using a refrigerant (freon) and letting it change its state to take the heat out of the air. This refrigerant is in a sealed law which should never have to be replaced or recharged. When a allowable facility of an air conditioner is performed the contractor should put a vacuum on the law to check for any leaks. If there is a leak in the law it needs to be found and repaired. This is where the qoute normally comes into effect. While the facility process either man had a bad braze weld or didn't put a vacuum pump on and there is a leak.

Air Conditioner

This leak could go undetected for a few years and by the time the customer notices it there is no more warranty on the product or installation. When an additional one contractor comes in to look for the qoute they just fill it up and take the easy money. This fee to fill with freon can range from 0-5 and after doing that a few times the customer can spend more than the law is worth. Not to mention the damage the low freon will do to your compressor and cause future problems.

Air Conditioner Freon Leak Repairs

The allowable thing to do in the case of a loss of freon is very easy, and after the fix you can be sure that you will never lose freon again.

What you need to see the contract rod is put the law into a positive pressure using nitrogen. By putting that much pressure in the law you will be able to hear the nitrogen leak and mend the problem. If the qoute is in the surface or inside coils you need to have them replaced. Hopefully the leak was in one of the former welds and can just be touched up. After the mend there needs to be a vacuum put on the system. By bringing the law to a negative pressure you remove all of the noncondensables and any moisture in the system. Let this vacuum sit for an hour and see if there is any loss. If not recharge to facility standards and you air conditioning law will work well for a long time.

Air Conditioner Freon Leak Repairs

Suncast PB6700 Patio Bench Nerf Super Soaker Tornado Strike